Every cutting process of automatic fiber laser coil material cutter reflects the attention of mechanical technicians. Their efforts make the performance of fiber laser cutting not disorderly, safe and efficient. As we all know, the workpiece weighs several hundred kilograms on the workbench, so the optical fiber laser cutting machine is not easy to move. Adjusting and using the automatic edge detection function of the winding of the automatic optical fiber laser cutting machine can save time to adjust the workpiece and promote the efficiency of the machine.

　　用每一種熱切削技術，只有少數情況下可以從板的邊緣開始，一般情況下，板上必須有一個小孔。在以前使用的激光復合沖壓機是先沖孔出孔，然后激光從孔中開始切割。

　　With each kind of hot cutting technology, only a few cases can start from the edge of the plate. In general, there must be a small hole in the plate. In the past, the laser composite punch was used to punch the hole first, and then the laser cut from the hole.

　　脈沖射孔代替爆破射孔，用于小孔的加工。因此，激光能量過于集中在一個小的區域，這使得非加工區域燒焦，導致孔洞變形，影響加工質量。光纖激光切割機此時應在處理程序中將脈沖射孔方式改為爆破射孔方式，解決光纖激光切割機的問題。然而，對于低功率的激光切割機來說，情況恰恰相反。光纖激光切割機

　　Pulse perforation instead of blasting perforation is used to process small holes. Therefore, the laser energy is too concentrated in a small area, which makes the non-processing area burning, leading to hole deformation, affecting the processing quality. In order to solve the problem of fiber laser cutting machine, the pulse perforation mode should be changed to the blasting perforation mode in the processing program. However, for low power laser cutting machines, the opposite is true. Optical Fiber Laser Cutting Machine

　　根據自動卷料工作原理和光纖激光切割機的設計原理，分析了光纖激光切割機產生毛刺的主要原因如下:向上和向下的激光焦點位置是不正確的,你需要做焦點位置測試,根據偏移量的調整,激光輸出功率是不夠的,需要檢查激光發生器工作是否正常,如果正常,然后觀察激光的輸出控制按鈕的值是正確的,試著調整光纖激光切割機,切割速度太慢,需要增加操作控制的線速度。

　　According to the working principle of automatic coiling and the design principle of optical fiber laser cutting machine, the main reasons for burrs in optical fiber laser cutting machine are analyzed as follows: the laser focus position up and down is incorrect, you need to do the focus position test, according to the adjustment of offset, the laser output power is not enough, you need to check whether the laser generator works normally, if it is normal, and then observe the excitation. The value of the output control button of the light is correct. Try to adjust the optical fiber laser cutting machine. The cutting speed is too slow. It needs to increase the linear speed of the operation control.